Pro Solar Panama – 800mm Solar Powered Bollard Light
From: £245.00
UK Registered Design: 6074584
The Panama Solar Powered Bollard Light is a 140mm diam. bollard with anti glare top designed to help direct the light downwards. At dusk, the Panama solar powered bollard light will illuminate at full brightness, and then follow a gradual dimming sequence until it reaches 30% brightness after 5 hours. From then on it will remain at 30% until dawn Even in the dullest of weather, our solar lights will still illuminate, although they may not last the entire night cycle, which in many cases is not a necessity.
IK IMPACT TESTED – See specifications below for more information
Please note, if located very close to the coast, this may affect the finish of the bollard.
Please allow up to 2-3 working days for delivery.
Pro Solar LED Bollard Light – 800mm
KEY FEATURES
- Monocrystalline Solar Panel (up to 25 year life)
- Replaceable LiFePO4 Lithium Battery (LFP long life)
- High Output Daylight or Warm White Epistar LEDs (240 lumens)
- Down Light / Spread Light Glare Shield Top
- Durable Die Cast Aluminium (IK10) & High Impact Polycarbonate (IK06)
The Panama Solar Powered Bollard Light is a 140mm diam. bollard with anti glare top, designed to help direct the light downwards. The high impact, detailed polycarbonate lens and internal reflector diffuses light evenly. Epistar LED chips (2W) generate a high lumen output with up to 50,000 hours life. Optimum charge levels are maintained due to the substantial monocrystalline solar panel and replaceable LifePO4 lithium battery. The wider top enables a large solar panel to be installed and prevents light pollution.
The Panama Solar Powered Bollard Light is the perfect solution to path lighting. It is both simple and safe to install, with no restraints on positioning, in comparison to mains fittings. It is environmentally friendly, converting natural energy into electrical current. Furthermore, solar lighting is completely free to run.
Dimming Sequence & Active Smart Power System
The Panama uses intelligent time controllers, calibrated to the UK climate, to prolong battery life without compromising on brightness levels. These time controllers operate a gradual dimming sequence to maintain a brighter light when it is needed most, in the early hours of darkness, and a less bright light when it is needed less, often in the early hours of the morning. In addition, the Panama’s Active Smart Power System (ASPS) further reduces light emission when the battery voltage is low, resulting in longer-lasting light functionality. The Panama is also available with motion sensor here.
At dusk, the Panama solar powered bollard light will illuminate at full brightness, and then follow a gradual dimming sequence until it reaches 30% brightness after 5 hours. From then on it will remain at 30% until dawn. As a result, battery charge is retained for longer than other alternatives sequences. Even in the dullest of weather, our solar lights will still illuminate, although they may not last the entire night cycle, which in many cases is not a necessity. The on/off switch is concealed by a waterproof plug which is also much less noticeable.
Panama solar bollard light easily lasts all night (9+ hours). It had 7 hours charge total. Subsequently, unused power will carry over into the next day. Performance may vary depending on the amount of sunlight.
Please allow up to 2-3 working days for delivery.
| Range | Pro-Solar |
|---|---|
| Wattage | 2w |
| LEDs | 2W, SMD 2835 LED Chips |
| Colour Temperature (kelvins) | Daylight White – 6000K, Warm White – 3000K |
| Lumen Output | 240lm |
| Beam Angle | 120 Degrees |
| Illumination Time | Up to 23 Hours at Full Charge |
| LED Expected Life | Up to 50,000 hours |
| Wattage Equivalent | 10W CFL / 42W Incandescent |
| Sensor | Light Sensor (Photoreceptor) |
| IP Rating | IP65 |
| IK Rating | Main Body = IK10 |
| Battery Type | 3.2v 12AH LifePO4 Lithium Battery – REPLACEABLE |
| Solar Panel | 5v / 3.5W Monocrystalline Solar Panel – approx 25 year life |
| Charging Time | 8 hours (AM1.5 1000W / m² 25ºC) |
| Working Temperature | -25ºC ~ 55ºC |
| Weight | 4.7 KG |
| Materials | Die-cast Aluminium, Polycarbonate |
| Mounting Option | Surface Mount (As Standard), Root Mount J-Bolts Kit (+£7.50) with Dome Caps, Ground Spike Kit (+£35.00) |
| Dimensions | Height = 800mm |
| Guarantee | 5 Years |
| Certification | UKCA, CE, RoHS |
| UK Registered Design | 6074584 |
| Waste Disposal / Recycling | Batteries: BPRN0843, Electrical: WEE/KC3440XY |
You may also like…
Cleaners, Sealants & Lubricants
Motion Sensor Bollard Lights
Solar Bollard Lights
Motion Sensor Bollard Lights
Mounting Accessories - Ground Spikes, Bases, Extension Poles
Stainless Steel 4 Fin Ground Spike for Pro Solar Bollard Lights – 50cm
Pro-Bollard Accessories and Spares
